22261 Autoloader 2 ALE2: Plate did not arrive in conveyer after ejecting. Trendsetter_VLF_Auto By the time that the fetch or fetch-eject has parked the picker, the plate must have arrived in the conveyor. (arrived means that the conveyor in sensor (Xaxis for Lconv) must have been triggered.) If the plate did not arrive and did not already fully enter (trailing edge past in sensor) then this error is reported. It would happen if the plate were removed from the table before ejecting took place. Resume will continue and assume that the plate was removed and cancel the conveyor eject. Plate did not arrive at conveyor - possible no plate on unload table ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:01 2008 PST